MCC MIIC-203 Guida Utente Scaricare il pdf (Pagina 56)

these control characters are normally automatically stripped out of the data stream

by Host communication driver software, and are not visible at the application

program level.

The RTS/CTS protocol requires a serial port, cabling, and Host communication

driver software that supports the additional control signals.

Command: /F[0|1][CR] Flow Control [0 = XON/XOFF, 1 = RTS/CTS]

Response: * 'iPort/USB Ready

Default Setting: XON/XOFF

C General Call Control

Enables or disables iPort/USB response to I

C Bus General Call (Address x00)

messages.

Command: /G[0|1][CR] 'I

C General Call [0 = Disabled, 1 = Enabled]

Response: * 'iPort/USB Ready

Default Setting: Enabled

Hex Only Display Control

Controls Hex Only (~00...~FF) output of Master or Slave received data.

When enabled, all received I

C message data bytes are displayed in Hex

(~00…~FF) format. When disabled, received I

C message data bytes representing

ASCII printable characters (x20...x7F) are displayed as their ASCII printable

character. Non-ASCII printable data bytes are always displayed in Hex (~00…~FF)

form.

Command: /H[0|1][CR] 'Hex Only Display [0 = Disabled, 1 = Enabled]

Response: * 'iPort/USB Ready

Default Setting: Enabled

Set iPort/USB’s Own I

C Slave Address

Sets iPort/USB's own I

C Slave Address (Hex 2...FE). Subsequent I

C messages to

this address will cause iPort/USB to become an active Slave device on the bus.

Command: /Ixx[CR] 'Set iPort/USB’s Own I

C Slave Address

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 76 77

Nessun commento

MCC MIIC-203 Guida Utente Pagina 56